|NOTICE: This store is closing
Kits | Books | Gadgets | Cables | Servo Components | Services | Stepper Drivers
|Use this cable to connect a single axis stepper controller with a PMinMO compatible connector^ (Linistepper, SLAm, etc...) to its break out board. |
Note: When used with our 4Axis board, only two non-adjacent axis can be connected with this cable. E.g. X and Z or Y and A. This limitation is due to the spacing of the axis headers on the 4Axis board; which was required to support the use of a single 2x20 IDC cable which fans out to 4 separate 2x10 PMinMO drivers. If you need more than 2 axis, use the 4Axis cable instead.
James Newton's MassMind.org offers Kits, Books, Gadgets, Cables, Servo Components, Services, and these Stepper Drivers: