please dont rip this site

Cyclic Redundancy Check Data Link Error Detection / Correction Method

CRC error detection computes the remainder of a polynomial division of a generator polynomial into a message. The remainder, which is usually 16 or 32 bits, is then appended to the message. When another remainder is computed, a nonzero value indicates an error. Depending on the generator polynomial's size, the process can fail in several ways, however. It is very difficult to determine how effective a given CRC will be at detecting errors.

The probability p that a completely random (bad) message will be incorrectly accepted as valid (not detected as a CRC error), is completely a function of the code rate: p = 2-r = 2-(n - k). Where

Use of the CRC technique for error correction normally requires the ability to send retransmission requests back to the data source.

Comments:

David A Cary Says:

16-bit CRC routine (isochronous) for the polynomial 0x8005
Scott Dattalo, Dave Dribin (2002-08-24)
http://www.piclist.com/techref/postbot.asp?by=time&id=piclist\2002\08\24\233838a&tgt=post
+

A quick guide to CRC: With example calcuation of CRC 16 by Pierre Desrochers +

See also:

Code:


file: /Techref/method/error/crc.htm, 6KB, , updated: 2011/11/28 20:08, local time: 2024/12/27 04:41,
TOP NEW HELP FIND: 
18.226.187.60:LOG IN

 ©2024 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?
Please DO link to this page! Digg it! / MAKE!

<A HREF="http://ecomorder.com/Techref/method/error/crc.htm"> Cyclic Redundancy Check error detection</A>

After you find an appropriate page, you are invited to your to this massmind site! (posts will be visible only to you before review) Just type a nice message (short messages are blocked as spam) in the box and press the Post button. (HTML welcomed, but not the <A tag: Instead, use the link box to link to another page. A tutorial is available Members can login to post directly, become page editors, and be credited for their posts.


Link? Put it here: 
if you want a response, please enter your email address: 
Attn spammers: All posts are reviewed before being made visible to anyone other than the poster.
Did you find what you needed?

 

Welcome to ecomorder.com!

 

Welcome to ecomorder.com!

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

  .