please dont rip this site

SMD: Surface Mount Device Soldering

SMDs are mounted using: reflow soldering, wave soldering and hand soldering.

Reflow:

Toaster ovens or hardware store hot air guns for smt reflow.

http://www.sparkfun.com/tutorials/59 Reflow soldering on a skillet.
http://youtu.be/CO2Vv0YztBE Solder paste can be manually applied and components placed and re-flowed in a toaster oven

Wave:

Use electric skillets for dip (wave) soldering and tin/lead plateing. The basic problem with home plating is that a roundness forms that causes the leads to slip off the pads. You can use wick to remove the the rounded tops. "Mopping" the solder over the board with an iron can result in uneven solder hight which can prevent all the chip leads from contacting the pads. Again, solder wick can remove "bumps"

One problem is that the package picks up moisture and turns to steam if heated rapidly as in wave soldering. This can cause delamination of the plastic from the die or leadframe^. I've observed the problem appearing as blown output pins. Smaller packages are rarely a problem. Typically you can pre-bake the chip for 12-24 hours at low enough temperatures to prevent rapid generation of steam (Altera suggests 12hrs at 260F).

http://www.cornwell.demon.co.uk/micro1.htm MELTING METALS IN A DOMESTIC MICROWAVE


file: /Techref/pcb/smd/soldering.htm, 2KB, , updated: 2012/12/24 13:18, local time: 2024/3/29 03:44,
TOP NEW HELP FIND: 
54.81.136.84:LOG IN

 ©2024 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?
Please DO link to this page! Digg it! / MAKE!

<A HREF="http://ecomorder.com/techref/pcb/smd/soldering.htm"> SMD: Surface Mount Device Soldering</A>

After you find an appropriate page, you are invited to your to this massmind site! (posts will be visible only to you before review) Just type a nice message (short messages are blocked as spam) in the box and press the Post button. (HTML welcomed, but not the <A tag: Instead, use the link box to link to another page. A tutorial is available Members can login to post directly, become page editors, and be credited for their posts.


Link? Put it here: 
if you want a response, please enter your email address: 
Attn spammers: All posts are reviewed before being made visible to anyone other than the poster.
Did you find what you needed?

 

Welcome to ecomorder.com!

 

Welcome to ecomorder.com!

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

  .