Ammonia / Water Absorption Refrigeration

Water and ammonia combine easily. So, they combine at room temperature. Heat can then be applied to distill the Ammonia from the water and condense it in a separate container. The distilled Ammonia will then evaporate at less than room temperature and re-combine with the water. It is the evaporation of the Ammonia that then cools the container and the continued absorption of the evaporated Ammonia back into the water that allows the evaporation to continue until all of the distilled Ammonia is gone.

The obvious problem with this is that Ammonia is a terribly toxic chemical and any mechanical failure of the system which allows it to escape into an enclosed, inhabited space is likely to result in death. Zeolite / Water Adsorption systems, which work on more or less the same principle, are therefore much preferred.

See also:

• http://www.humboldt1.com/~michael.welch/extras/solarice.pdf (cached 991001) Solar absorption cooling
  
• http://www.ggw.org/cac/IcyBall/crosley_icyball.html Crosley IcyBall refrigeration. Ammonia and water in a heating / cooling cycle
  http://crosleyautoclub.com/IcyBall/HomeBuilt/HomeBuilt.html
  http://crosleyautoclub.com/IcyBall/HomeBuilt/HallPlans/IB_Directions.html
  

Questions:

• SPAMpeteandlizspam at -Remove-optusnet.com.au asks: " I have aquired an Icyball that has no charge left in it due to a leak. Does anyone know the correct ratio of water/ammonia." James Newton of James Newton's Massmind replies: As per: http://crosleyautoclub.com/IcyBall/HomeBuilt/HallPlans/IB_Directions.html "I think the original Crosley Icyball charge was approximately 6 pounds anhydrous ammonia and 8 pounds water"+

  .