Language Pcl LJ1901.ASC

DRAWING ARCS

     
     The Arc Absolute or AA , and the Arc Relative or AR
     command use the following method for drawing arcs. Your
     current pen location becomes one end of the arc; you
     specify the center point with one parameter (setting
     the radius), and set another parameter to specify the
     number of degrees through which you want the arc drawn.
     For more information see the PCL 5 Printer Language
     Technical Reference Manual.
     
     LEGEND: Ec = [Ctrl] [P] Esc] in DOS EDIT
     
     
     EcE                           Resets the printer.
     
     Ec%0B                         Enters HP-GL/2 mode.
     
     IN;                           Initializes HP-GL/2.
     
     SP1;                          Selects pen number 1
                                   (black). Even though
                                   there is no physical pen,
                                   the SP command must be
                                   used to enable printing.
     
     PA4200,2900;PD;               Sets starting point to
                                   (4200,2900) and sets pen
                                   down.
     
     AA4600,2500,-180;             Using the Arc Absolute
                                   command, specifies the
                                   pivot point of the arc,
                                   thereby setting the
                                   radius; draws the arc for
                                   180 degrees, in a
                                   negative angle of
                                   rotation, (clock-wise).
     
     Ec%0A                         Enters PCL mode.
     
     EcE                           Sends a reset to end the
                                   job and eject the page.
     
     
     
     
            Copyright  Hewlett-Packard Co. 1993
   The information contained herein is subject to change
                      without notice.
   Hewlett-Packard shall not be liable for incidental or
  consequential damages in connection with the use of this
                         material.

     

  .