please dont rip this site

WKED_B (Mode=0Ah) Set the bit to 1 to sense failing edge, clear to 0 to sense rising edge, not vice versa as stated in the SX Datasheet page 9

The only way to get the SX to generate an interrupt when the comparator output at RB0 goes from low to high would be to connect the output pin to another pin on port B configured as an interrupt with its interrupt enabled. In other words, the interrupt for MIWU on port B does not also work when the port direction is set to output.

file: /Techref/scenix/inst/wked_b.htm, 0KB, , updated: 1999/2/20 12:23, local time: 2024/11/26 02:22,
TOP NEW HELP FIND: 
18.188.110.150:LOG IN
 ©2024 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?
Please DO link to this page! Digg it! / MAKE!

<A HREF="http://ecomorder.com/Techref/scenix/inst/wked_b.htm"> scenix inst wked_b</A>
After you find an appropriate page, you are invited to your to this massmind site! (posts will be visible only to you before review) Just type a nice message (short messages are blocked as spam) in the box and press the Post button. (HTML welcomed, but not the <A tag: Instead, use the link box to link to another page. A tutorial is available Members can login to post directly, become page editors, and be credited for their posts.


Link? Put it here: 
if you want a response, please enter your email address: 
Attn spammers: All posts are reviewed before being made visible to anyone other than the poster.
Did you find what you needed?
 

Welcome to ecomorder.com!

 

Welcome to ecomorder.com!

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

  .